But you may use pliers to make two to three tiny outward bends on the duct so the hose doesn’t slide out. These small cuts will make the end more pliable, and you can steadily slide it onto the duct, tighten the clamp, and seal the installation with aluminum foil tape.ĭo not use screws to fasten the hose to the duct. So, you have to flex the semi-rigid dryer vent hose to make it fit on the duct in the wall.Īn easy and practical way to flex the hose is by making two to three small cuts on the end you want to slide onto the duct. Unlike the dryer’s vent tube, the duct is a female port and therefore slightly bigger. How To Fit a Dryer Vent Hose on the Duct in the Wall?įlattening the ridges of a dryer vent hose may not be enough for it to fit onto the duct in the wall. This rounded connector slides effortlessly and fits snugly on a dryer’s vent, which is a male exhaust tube. The other end of the Deflecto elbow is a female connector with an opening of 4″ (10 cm) but without any ridges. You can easily slide a 4 in (10 cm) vent hose onto this slightly smaller crimped port. ![]() So, you can adjust the elbow as necessary so the hose alignment from the dryer vent to the duct doesn’t have any structural issues.Īlso, this elbow’s crimped end is 3.875 inches (9.84 cm), which is its male port. This dryer vent elbow has a 0° to 90° adjustable bend. You may consider a Deflecto Aluminum Dryer Vent Elbow (available on ). If you have to choose between a coupler and an elbow, I recommend the latter because of the extra benefit of aligning the hose appropriately. The regular rounded female port of a coupler connects to a dryer’s vent, which is a male tube.Īn elbow is a coupler or connector, but it also facilitates a bend or turn so you can align the hose from the dryer vent to the duct as necessary. The smaller or tapered end is the male port that connects to the hose. The second and third options require additional parts.Ī coupler is a connector with male and female ports. The slightly flattened end should slide onto the dryer’s vent outlet. This flattening should give you a tiny bit of leeway with a semi-rigid metal hose or transition duct. You can use a PVC pipe or roller to flatten around 2 to 3 inches (5 to 7.6 cm) of the ridges of the hose at one end. The first option doesn’t require any special tool or an additional fixture.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |